Call us now ! Send us an email http://maps.google.com/maps?q=11904 Old San Antonio Rd Manchaca United States

Back to Top

Call Us Today!
(512) 282-9303
Call Us Today!
(512) 282-9303

Cleaning Procedures & Recommendations

Floor Surfaces

Dust mop interior floors frequently using a clean non-treated dry dust mop. Sand, dirt and grit do the most damage to natural stone surfaces due to their abrasiveness. Mats or area rugs inside and outside an entrance will help to minimize the sand, dirt and grit that will scratch the stone floor. Be sure that the underside of the mat or rug is a non-slip surface. Normally, it will take the average person about eight to ten steps on a floor surface to remove sand or dirt from the bottom of their shoes.

Do not use vacuum cleaners that are worn. The metal or plastic attachments or the wheels may scratch the surface.

Other Surfaces

Clean stone surfaces with a few drops of neutral cleaner, stone cleaner (available in our show room) or a mild dishwashing detergent and warm water. Use a clean rag mop on floors and a soft cloth for other surfaces for best results. Too much cleaner or soap may leave a film and cause streaks. Do not use products that contain lemon, vinegar, or other acids on marble or other calcareous stones. Rinse the surface thoroughly after washing with the soap solution and dry with a soft cloth. Change the rinse water frequently. Do not use scouring powders or creams; these products contain abrasives that may scratch the stone.

Bath and Other Wet Areas

In the bath or other wet areas, soap scum can be minimized by using a squeegee after each use. To remove soap scum, use a non-acidic soap scum remover or a solution of ammonia and water (about ½ cup ammonia to 1 gallon water). Frequent or over use of ammonia solution may eventually dull the surface of the stone.

Outside Pool or Patio Areas

In outdoor pool, patio and hot tub areas, flush with clear water and use mild bleach solution to remove algae or moss.